Recent content by Edhawk

  1. Edhawk

    Safe to update from Catalina 10.15.5 to 10.15.6 ?

    You can also install the Supplemental update for Catalina 10.15.6.
  2. Edhawk

    Safe to update from Catalina 10.15.5 to 10.15.6 ?

    Yes, it worked just fine on my AMD FX system. Just remember to create a backup/clone of your current drive, before running the update.
  3. Edhawk

    Mojave randomly wakes up from sleep

    Sounds like something is wrong with your USB configuration, if the keyboard hub is acting in the manner described. The Bluetooth and card reader (USB2.0-CRW) should be the only Internal USB 2 devices. I am not sure they should both be connected on port HS11. I would normally assume they are...
  4. Edhawk

    Mojave randomly wakes up from sleep

    Have you tried one of the other Hibernatemode settings mentioned in the guide, i.e. Hibernatemode=3 or 25 in place of 0? From the information provided in the post above I would comment as follows: You are using SoundFlower audio volume app/controller. Have you tried running the system with...
  5. Edhawk

    [SOLVED] Catalina 10.15.2 don't boot with RX 5700 XT

    @rafbits I have had a quick look at your OC folder and would comment as follows: Kexts: You have FakeSMC.kext present in your /OC/kexts folder. As you are using VirtualSMC.kext it it probably just as well that FakeSMC.kext is not being injected, i.e. the kext is not included in your...
  6. Edhawk

    I have an issue with the Integrated Graphics,,

    You probably need to change the AAPL-ig-platform-id in your config.plist. This can be found under the DeviceProperties section of your When using just the IGPU (UHD 630) you need to inject the following Platform ID 0700923E, which equates to the 0x3E920007 platform ID used for a Coffee Lake...
  7. Edhawk

    Mojave randomly wakes up from sleep

    Have you looked at the Hibernation and sleep settings your system is using? Have a read of this guide by Allan over at InsanelyMac - Configuring the USB ports, setting the correct Power/Energy Saving...
  8. Edhawk

    Remove Audio Output Devices?

    One possible reason for you seeing the multiple audio devices is that your system is using different/multiple kexts to create the audio devices present in your system. You should check that you don't have any other audio kexts other than AppleALC.kext installed/injected, either from your...
  9. Edhawk

    Remove Audio Output Devices?

    How have you activated the built-in Audio devices? I assume WhateverGreen.kext is providing the necessary patches for your dGPU's DP/HDMI audio. The best way to get your motherboard audio working is to inject Lilu.kext & AppleALC.kext with the correct Audio Layout ID injected from your...
  10. Edhawk

    Graphics glitches after Mojave install

    Have a look this fix for legacy graphics by Chris111 - Installing the Legacy Video Patcher should work for your HD2500 IGPU, according to reports on other sites where this patcher has been discussed -...
  11. Edhawk

    [Solved] Updating OpenCore 0.5.9 to 0.6 (BlacklistAppleUdate)

    The 'BlacklistAppleUpdate' option has been removed from OpenCore 0.6.0 Release. It has been replaced with the 'run-efi-updater' NVRAM variable, according to the latest release documentation. Remove the BlacklistAppleUpdate option from your OC config.plist
  12. Edhawk

    Help! Fenvi T919 Airdrop is spotty at best

    Look at the AirDrop settings on your Hack. You may need to change them to allow the system to interact with your other devices. Open Finder, navigate to the AirDrop tab, check the 'Allow me to be Discovered By...' option is not set to 'No One', as shown in the first screenshot below. Make...
  13. Edhawk

    DW 1560 big sur beta 3

    Which VoodoPS2 kext are you using, Acidanthera’s or Rehabman's? if using acidanthera’s version are you also using/injecting VoodooInput.kext?
  14. Edhawk

    z97-d3h i7 4790 rx580 8gb nitro+ mojave 10.14.6

    I've downloaded your EFI folder and will have a look at this tomorrow.
  15. Edhawk

    All-out video editing Hackintosh Build

    The SSDT's created using Corpnewt's SSDTTime script would be better than the pre-built ones, as they would be specific to your system, as they are based on your specific boards DSDT. I will have a look at the EFI folder and two log's and see what I can suggest, probably nothing forthcoming till...